What programming control design does the spring machine have?

It's no surprise that the installer writer can't be reset to zero. The key is to check that the spring machine is in all good condition. The key to the principle of producing yellow is to use the reaction force to send the wire directly to the front of the wire, and use the wire gauge to block the wire directly in front of the wire, so that the wire cannot be approached, causing friction resistance. Related design.

1. The main parameters of the controller are difficult (this is only limited to the internal work of the spring machine manufacturer). If the zeroing point of the machine is different after each zeroing, consider whether the gear ratio of the electronic equipment can be properly set.

2. Check whether the light yellow triangular traffic light on the upper right of the multi-function computer spring machine screen can move in the opposite direction, and check the screen condition. All normal zeroing operations will be performed. If there is, it will damage the circuit board; if the reset operation does not move in the opposite direction or accidentally reverse the direction, please open the back cover of the machine, modify the reset operation, and check whether the indicator light near the power switch will flash normally throughout the week machine. If everything doesn't flash properly, get close to the power switch and hold it with your hand. Immediately touch the machine throughout the reset process. If the proximity power switch is still off, check that the proximity power switch is connected to the circuit board. Whether the power plug of the power adapter is loose, or it can be judged that the problem is close to the power switch itself.