What is the reason for the Y-axis servo alarm of the spring machine?

The Y axis is the wire feed axis of the Uspring machine. It uses a Y-axis servo motor and transmission gear to operate the wire feed. "Y-axis servo alarm" is one of the common system alarms during the use of the spring machine. The Y axis appears on the spring machine. What is the reason for the servo alarm?

If the system "Y-axis servo alarm" occurs during the operation of the spring machine, it means that the machine tool has a corresponding fault during the operation. Such a failure will affect the production of the equipment, and it is necessary to find the cause according to the alarm prompt before it can be cancelled.

Below, Zhejiang Omnipotent Spring Machine Co.,ltd. will share with you the common factors that will cause the Y-axis servo alarm of the spring machine:

① Failure of electrical components caused by servo motors, drives, encoders or inverters, etc.

 ② Mechanical failure caused by dust or iron filings stuck

③ For man-made faults caused by abnormal operation, in addition to the above-mentioned main reasons, check item by item to eliminate the possible causes of the fault.

Sometimes external factors can cause the machine to not work. For example, improper operation of external signal lines can cause the spring machine to not work properly. .

There are many factors that cause the "Y-axis servo alarm" of the spring machine system. You can shut down and restart the machine to see if the system alert message clears. Then check and eliminate the fault according to the specific situation, so as to find out the cause of the fault, and strive to eliminate the fault in a short time and resume production. If you can't find the cause of the failure or how to troubleshoot it, you need to seek help from the spring machine manufacturer immediately, and ask a professional to repair it. In this way, production can be resumed as soon as possible to avoid secondary damage to the spring machine due to failure.