What are the factors that cause the spring pitch of the compression spring machine to be high and sometimes low?

In the normal operation process of the compression spring machine, the adjustment work of the compression spring machine is indispensable. When a certain spring product is adjusted, it can be mass-produced under normal circumstances. If there are some changes in the specifications and models of the springs in mass production, the high and low pitches during the winding process will often cause them. Everyone should make adjustments immediately to carry out the quantity according to the warranty period. The daily tasks of production and processing, and then for everyone to explain in detail the factors that cause the pitch to be high and sometimes low during the spring coiling process of the compression spring machine.

The pitch diameter caused by the work garment mold of the compression spring machine is always high and sometimes low. Work clothes molds are very important for compression spring machines. In addition to being wearable parts, some also require professional technology to adjust the goods to be uniquely produced, such as mirror processing, rounding and grinding. Operation process such as auxiliary knife. In addition, after the operation process staff carry out the adjustment work, they must undergo careful and continuous trimming until the machinery and equipment exceed the stable and rapid production and processing.

The pitch diameter caused by the equipment of the compression spring machine is always high and sometimes low. In addition to the quality of the machine and equipment, the starting point of the X-axis is the first factor that causes the pitch of the compression spring machine to be high and sometimes low during the spring coiling process. Among them, the X-axis starting point movement is divided into the physical starting point transition and the DC servo motor starting point deviation. For example, during the program operation command, the starting position of the X-axis command operation changes, the total number of coils of the wound spring is always the same, and the pitch diameter changes. When there is a misalignment at the starting point of the X-axis, it is recommended to seek a solution from a professional technology or manufacturer.

The pitch diameter caused by the cable of the compression spring machine is sometimes high and sometimes low. At present, the application of cold drawn steel wire in the market is relatively common. Due to the differences in the production process, professional process and cost control, customers have a variety of cable choices. Therefore, for the same computer compression spring machine used under the same specification, the credibility of the coiled spring is all different due to the different cables used.