How to maintain and service the 8-axis CNC spring wire bending machine during long-term use?

During long-term use, maintenance and service of the 8-axis CNC spring wire bending machine is the key to ensure its stable operation and extend its service life. Clean the environment around the equipment every day to prevent dust and debris from entering the machine. At the same time, regularly clean the inside of the machine, especially the sliding parts and transmission mechanism, to remove accumulated dust and debris. Check whether all parts of the CNC spring machine are tight during work every day, including fasteners such as screws and nuts. If they are loose, they should be tightened in time to prevent parts from falling off or being damaged. Regularly add an appropriate amount of lubricating oil or grease to the sliding parts, transmission mechanisms and bearings of the machine to reduce friction and wear and improve the operation efficiency of the machine.
Frequently check whether the control circuit of the CNC spring machine is good, including wires, cables, connectors, etc. If problems are found, they should be repaired or replaced in time to prevent circuit failures from causing machine shutdowns. Electrical equipment needs to be maintained at regular intervals, including removing dust accumulation and checking whether the wiring is loose. At the same time, the operating status of electrical equipment such as motors and transformers should be checked regularly to ensure their normal operation.
According to the use of the machine, the circulating system oil should be replaced regularly to maintain the cleanliness and lubrication performance of the oil. After the new machine has been operated for a certain number of hours (such as 1000 hours), the circulating system oil should be replaced. Regularly check the wear of the transmission mechanism, including gears, chains, belts, etc. If there are severely worn or damaged parts, they should be replaced in time. Regularly check the accuracy of the machine, including the positioning accuracy and repeated positioning accuracy of each axis, to ensure the quality and stability of the processed products.
If the machine is not used for a long time, it should be shut down for maintenance, and the inside and outside of the machine should be thoroughly cleaned to remove all dust and debris. Lubricate all sliding parts and transmission mechanisms to prevent rust and jamming. Cover the machine with a clean cloth or plastic film to prevent dust and moisture erosion.
Before performing any maintenance and maintenance operations, the power supply must be cut off to prevent electric shock or accidental start-up of the machine. When performing maintenance and maintenance, the operator must strictly follow the operation manual and maintenance recommendations to avoid damage to the machine or safety accidents. For complex repairs and maintenance work, it is recommended to entrust professionals to operate to ensure the quality and safety of the repairs.